EVOALL on 2016 Mustang PTS: I tries to install the EVOALL as a remote starter and bypass module (standalone?). Connected all the wires per the instructions (CAN, +12V, Parking lights, Ignition, ground). Updated firmware. Updated F/W options. Programmed the bypass "successfully". Press lock x 3. I hear the relay inside the EVOALL clicking but there is no power to the car and ofcoourse no start. Receive red flashes indicating "no tach". How does the unit start a car when there is no starter, ignition, or 12V power output from the EVOALL to the car? Is EVOALL only a bypass module? I dont see how the car can start without tose connections unless these signals are being sent through the vehicle CAN BUS, which I dont believe is the case.
Also after installing the EVOALL and trying repeatedly to start the car, my dome lights are continuously flashing and I can not turn them off.
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
